|
|
|
Who's Online
There currently are 5821 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
 ;
Great to be able to set channels again, on an old but stoll fine working TV
4gb94600.fm Page 15 Wednesday, September 11, 2002 6:07 PM
How to fill the salt container
From a water hardness category of 1� 2 (medium), before using the dishwasher for the first time, fill the salt container with regeneration salt (to find out the hardness level of water in your area, contact your local Water Board or check the last bill you received). If the water hardness level does not correspond to position 3 on the selector (setting on delivery) or if the water hardness level changes:
Hardness level 1 soft 1 - 2 medium 2 average 3 medium-hard 4 hard 5 extremely hard German degrees °dH 0-4 5-9 10 - 22 23 - 29 30 - 35 36 - 41 French degrees °fH 0-7 8 - 15 16 - 30 31 - 45 46 - 60 61 - 80
Setting the correct water hardness level: Set the water hardness by turning the selector inside the salt container. Use the table below to set the dial to the correct setting:
mmol/l
0 - 0,7 0,9 - 1,6 1,8 - 4,0 4,1 - 5,2 5,4 - 6,3 6,5 - 7,4
Clarke scale or English degrees °eH 0 - 5,0 6,3 - 11,3 12,5 - 27,5 28,8 - 36,3 37,5 - 43,8 45,0 - 51,3
Setting
If the water hardness level falls within category 1 (soft), no salt is required.
1 1 2 3 4 5
How to fill the salt container Warning: only use regeneration salts for use domestic dishwashers! Do not fill the salt container with unsuitable substances, such as detergent, as this will cause irreparable damage to the water softener system. 1. Remove the lower rack. 2. Unscrew the cap by turning it counter-clockwise. 3. When first using the dishwasher: fill the salt container to the rim with water.
4. Fill the salt container with regeneration salt to the rim (using the funnel provided) (when filling for the first time min. 1.5 kg and max. 2 kg) and stir with a spoon handle. 5. Screw the cap back on by turning it clockwise. 6. Fit the lower rack. 7. If regeneration salt is to be added, immediately start a wash programme (rinsing alone is not sufficient) in order to eliminate any residual saline solution straight away and avoid corrosion.
Salt level indicator The dishwasher is equipped with an electric or visual salt level indicator (depending on the model installed). Electric indicator The salt level indicator lamp on the control panel lights up when the salt container is empty.
Visual indicator The float is clearly visible in the cap window when the salt container is full (see photo). The float lowers and is no longer visible when the salt container is empty.
15
|
|
|
> |
|
