|
|
|
Who's Online
There currently are 5639 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual is complete with excellent quality! One suggestion, show number of pages and weather it is multi-lingual. The AD 600 Manuel is about 76 pages and over half is non English. This results in a larger print job than usually needed. Having this information, one could select the desired pages for printing.
 ;
I've been looking for a copy of the original user/owner manual. Just what the doctor ordered, thank you.
;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
ELECTRICAL CONNECTION
� Make sure the appliance is installed and connected to the electricity supply by a qualified technician in accordance with the manufacturer's instructions and in compliance with local regulations. The installer is responsible for the correct electrical connection of the appliances and the observance of the relative safety recommendations. � The appliance must be connected to the electricity supply by means of an all-pole disconnect switch with minimum contact gap of 3 mm. The appliances must be earthed by law. Do not use multiple plug adapters or extension leads. After the oven has been installed, the electrical components must be concealed.
� � �
�
Connecting the oven to the power supply
� Make sure that the voltage shown on the rating plate is the same as the power supply voltage in your home. The service number is located on the front edge of the oven cavity (visible when the oven door is open). Use a type H05RR-F power cord (minum length: 800 mm). Warning: All the oven's components operate at 230-240V. When using a 400 V connection, make sure that the voltage reaching the oven is 230-240V, as illustrated in the side table. Conductors X number 1N+ 2N+ 3+ 3N+ Electrical connection H05 RR-F 3X4 mmq H05 RR-F 4X2.5 mmq H05 RR-F 4X2.5 mmq H05 RR-F 5X1.5 mmq
� �
~ ~ ~ ~
Interconnecting cooktop and oven
� Before connecting the oven to the power supply, check that the cooktop is among the ones listed in the cooktop/oven pairing product sheet. Connect the 3 pole and 4 pole connectors to the respective connectors on the oven. The 3 pole connectors (H) is located at the rear right hand side of the control panel, the 4 pole connector (J) is located at the top of the oven in the left hand corner (see figure). Connect the yellow/green striped earth wire ( ) (K) from the cooktop to the screw located near the 3 pole connector. WARNING: DO NOT CONNECT TO THE POWER SUPPLY BEFORE YOU HAVE FINISHED CONNECTING THE OVEN AND THE COOKTOP. � 18 Mount the oven in the kitchen unit. Make sure the power cord is not entrapped.
�
�
|
|
|
> |
|
